Use this two template kit with your router to produce the finish mortise on both the door and the jamb. The strike (jamb) template will produce two mortises, the 1-1/8” x 2-3/4” 'T' strike with the red plastic block-off plate removed and the 1-1/8” x 2-3/4” deadbolt strike with the red plastic insert block-off plate installed. The latch template will produce a finish mortise of 1-1/8” x 2-1/4” on the door edge. Each template has two nail assemblies to attach the templates to the jamb and door. Template set is supplied with two red plastic Center Locators used to position the templates on the door and jamb in the proper position. Use our TG-1 Template Guide and our CB-1 or CB-4 Mortising Bits to produce perfect mortises. If you are purchasing our CB-4 Mortising Bit to use with this kit, you should also order our TBK-1 top bearing kit to use with the Strike template in this kit. See the TBK-1 kit in the ”Carbide Router Bits” section under ”Cutting Tools”. You can find these cutting tools and template guides listed on our web site.

Here are the links: Router Bits & Template Guides

Stock Number: LS-171B